Insulation contractor in Kings Mountain, NC - sealed attics and warmer floors
Complete Gastonia Insulation Services is an insulation contractor working in Kings Mountain, NC. We seal the gaps, clear out bad insulation and insulate attics, walls and crawl spaces in the houses people already live in.
Kings Mountain houses as we find them
Most of Kings Mountain sits in Cleveland County, with a small eastern piece in Gaston County, so the first thing we ask for is your address. The older streets around downtown have frame houses with low attics and crawl spaces, and the newer neighborhoods have rooms over the garage that run hot upstairs. We see the same mix next door in Bessemer City.
In an older house, somebody has usually insulated once already, sometimes twice, and not always in the right order. So we look at what's up there and under the floor before we add anything.
Services in Kings Mountain, NC
Attic insulation
Older Kings Mountain attics often have a few inches of packed-down fill and a hatch nobody's opened since the last owner, which is why the upstairs runs hot. We seal the gaps first, then add insulation evenly out to the edges without burying the eave vents.
Attic air sealing
Drafty rooms usually trace back to gaps around can lights, pipes, wiring and the attic hatch. We close those before any insulation goes on top, because insulation laid over a draft just works as a dusty filter.
Crawl space insulation
Cold floors in the older houses here usually mean batts sagging off the joists or lying on the dirt. We check the crawl space for water first, then insulate so it stays up and stays dry.
Insulation removal
When old insulation is soaked or full of droppings, putting new material on top only hides the problem. We bag it out and clean up before anything new goes in.
Home insulation
Plenty of houses here have one cold room, one hot room and a power bill that doesn't match either. Our home insulation work starts with finding where the heat gets out, then fixing it in the order that makes sense.
Spray foam insulation
The room over the garage in newer neighborhoods often has kneewalls, the short walls along a sloped ceiling, that leak air from the attic behind them. We use spray foam there because it seals and insulates at once on surfaces where batts won't stay put.
Working in Kings Mountain: permits, licenses and what sets the price
For a Kings Mountain address, permits go through the city's Planning Department, and Gaston County's building office doesn't cover the city, even though part of it sits in that county. If your job needs a permit, we settle it before we start, so the start date waits on the city. On a bigger project, the state's general contractor licensing board says a general contractor has to be licensed once the total job is valued at $40,000 or more, and that's worth knowing when you compare contractors.
We're licensed and insured, and when a job needs a permit, we check which city and county offices cover your address and handle the paperwork before work starts. The price mostly turns on what's already up there, what has to come out or be fixed first and how much of the house we're covering, while the schedule turns on any permit and on those fixes. I'll give you your own number at the estimate. We do the same work in Belmont and across the state line in Clover, which is why the address question comes early.
Why houses here end up needing this work
Older attics here tend to have the same problems. The insulation has settled thin, it's deep in the middle and bare at the edges, the gaps around lights and the chimney were never sealed, and sometimes the eave vents are buried so the attic can't breathe. We pull out what's soaked or dirty, seal the gaps, keep the vents open and lay new insulation evenly to the edges. We've also found more holiday decorations than insulation in a few attics, so clearing a path to the hatch helps.
Crawl spaces are the other half of the story, and the usual sign is a cold floor. We check for water before anything else, because insulation under a wet floor just holds the wet against the wood.
Get a free insulation estimate for your Kings Mountain house
We'll reply within one business day to set up a time. I'll come out to your Kings Mountain house, look things over and give you a free estimate on site, with no pressure and no obligation.
How it works when you call us in Kings Mountain
Call or send the form
Tell us what's going on, whether it's a hot upstairs, a cold floor or a high power bill. Give us your address early, because it tells us which city and county offices cover the job.
I come out and look
I check the attic, walls, crawl space or basement and note what's in the way. It helps if you clear a path to the attic hatch and the crawl space door.
You get a written estimate
I write it up and walk you through what has to be fixed before any insulation goes in. You decide from there.
We handle any permit
If the job needs one, we take care of the paperwork with the right office before work starts. The start date waits on the city when a permit is involved.
We fix, seal, insulate, clean
Our own crew fixes what comes first, seals the gaps, insulates and cleans up before leaving, and I check the work. Satisfaction guaranteed.
Insulation questions from Kings Mountain homeowners
Do I need a permit to insulate my house in Kings Mountain, NC?
Whether your insulation job needs a permit depends on what else it touches, because the city requires one for any new use or new structure, and work like plumbing or wiring can bring one in. If the job means moving wiring or finishing a room over the garage, ask the city's planning office, and we check it for your address before we start. Permit applications go through the city's online system, listed on the city's permits page.
How do I find out which government covers my Kings Mountain property?
Look up your address on the GIS maps from the city, Cleveland County or Gaston County, which show whether you're inside city limits, in the ETJ, the area just past the limits where the city's planning still reaches, or under county rules. Cleveland County's GIS site also shows property lines and zoning. We look this up before the estimate, since it decides where any permit comes from.
How much does insulation cost in Kings Mountain?
There's no honest number until we've seen the house, because the price depends on what you have now and what you want done. Foam costs more than blown-in, which is loose fill blown through a hose, and a tight attic or a low crawl space takes more labor than one you can stand up in. Removing old, wet insulation adds to the job, while a clean attic that just needs sealing and topping up usually costs the least.
How long does attic insulation take, and do we have to leave the house?
With blown-in insulation, you can usually stay home while we work, but spray foam is the one that sends everybody out. Foam has a re-entry time, meaning how long before you, the kids and the pets can come back inside, and I'll tell you that before we schedule. How long we're in the attic depends on its size and on what has to be fixed first, and you'll know that at the estimate.
What causes cold floors in an older Kings Mountain house?
Cold floors usually come from a crawl space with little or no working insulation, plus open gaps where pipes and wires pass through the floor. Batts that have sagged or fallen don't do much. We seal those gaps, deal with any moisture down there, then insulate so it stays in place.
Is spray foam or blown-in insulation better for my attic?
For most attics, sealing the gaps and topping up with blown-in is the better buy. Foam costs more because it seals air while it insulates, and that's worth it when your ductwork runs through the attic, since the ducts stay inside the sealed space. If your ducts aren't up there, I'll usually point you to sealing and loose fill.
Call about your Kings Mountain house today
We answer seven days a week from 6 AM to 11 PM, so call (980) 745-0005 or use the form and tell us which room is giving you trouble.